Bakers Pride c-24gs Manual De Usuario

Descargar
Página de 12
11. ADDITIONAL  INSTRUCTIONS:
(i) 
Keep the area around the broiler free and clear of all combustible material.
(ii) 
Provision of adequate supply of air to your broiler is essential. Provide for sufficient outside air to 
enter the broiling area and assure that this air flow is not obstructed.
(iii) 
Air enters the burner area from the front of your broiler only. Assure that this area is kept open and 
unobstructed.
12. INSTALLATION WITH CASTERS:
THIS IS AVAILABLE FOR FLOOR MODELS ONLY.
Four casters (two with wheel brakes) and the mounting hardware is packed and included in the shipment, if 
ordered. Install casters with wheel brakes on the front of the unit.
Installation of the unit should be made with a connector that complies with the latest edition of the Standard 
for Connectors for Movable Gas Appliances ANSI Z21.69, in the USA (CAN CGA-6.16 in Canada) and a 
quick disconnect device that complies with the latest edition of the standard for quick disconnect devices for 
use with gas fuel ANSI Z21.41 in the USA (CAN 1-6.7 in Canada.) Adequate means must be provided to 
limit the movement of the appliance without depending on the connector and any quick disconnect device 
or its associated piping to limit the appliance movement.
The restraint should be attached to the right side of the  back of the unit close to the gas inlet pipe.
If disconnect of the restraint is necessary, the restraint should be reconnected after the appliance has been 
returned to its originally installed position BEFORE the gas line is reconnected.
II OPERATING INSTRUCTIONS
ONLY  QUALIFIED  PERSONNEL,  PROPERLY  TRAINED  AND  FAMILIAR  WITH  THIS  EQUIPMENT 
SHOULD OPERATE THIS BROILER
.
1. LIGHTING INSTRUCTIONS: 
See Section 10 of Installation Instructions.
Once each individual Pilot Burner, or the Carry-Over Lighter Tube, is lit, the Main Burners of the broiler may 
be turned  “ON” ,  “OFF” or to “Low”  by turning the corresponding Control Knob located in the front of the 
Broiler under the Work Deck.
Note:  The  “Low”  flame  can  be  adjusted  up  or  down  by  turning  the  small  screw  in  the  center 
of the valve stem. (See Figure “E”)
2. BROILING:
BROILER  TOP  GRATES  MUST  BE  HOT  ENOUGH  TO  MAKE  BLACK  CHAR  MARKS  WHEN 
STARTING TO BROIL.
Adequate preheating time is necessary for the food to release from the broiler grates and to cook properly. 
Before Broiling, allow Radiant units to preheat for 10-15 minutes and Glo-Stone  units for 20-25 minutes.
(i) 
Do not press the juice out of the meat as this will dry out the meat.
(ii) 
After Broiling, allow the meat to sit covered on a heated platter for 2-5 minutes before cutting. This 
will allow the juices to 'settle' and the meat will be more moist.
(iii) 
Do not use forks or other sharp objects to poke holes in the meat. Do not cut the meat as it cooks.
(iv) 
Thick pieces of meat require longer broiling time with less flare-up. Reduce flare-up by trimming 
excess fat for a longer broil time without burning.
(v) 
Keep the unit clean. Food caught between the grate will not allow hot air to rise around the product. 
This will result in uneven heat, increase the cook time and can cause the Broiler to overheat which 
may result in permanent damage.
6