Lexmark Optra T Guía Del Usuario
47
Using the Operator Panel and Menus
Setup Menu
Use the SETUP MENU to configure a variety of printer features.
Setup Menu
Menu item
Values
Printer
Language
Language
PCL Emulation*
PS Emulation
PS Emulation
The printer language defines how the computer communicates with the printer. Your computer uses printer languages, such as
PCL emulation and PostScript emulation, to send print data to the printer. Setting a printer language as the default does not
prevent the software application from sending print jobs that use the other printer language.
PCL emulation and PostScript emulation, to send print data to the printer. Setting a printer language as the default does not
prevent the software application from sending print jobs that use the other printer language.
Power Saver
Disabled
1…120 (20*)
1…120 (20*)
The
Power Saver
menu item lets you reduce power usage when the printer is idle by determining the length of time (in
minutes) the printer waits after a job is printed before it goes to a reduced power state.
If you have selected a
Power Saver
value, the
Power Saver
message replaces the
Ready
message and becomes the new
printer default when the printer is in a
Ready
state. Both messages indicate the printer is ready to receive jobs.
If your printer is in constant use, select a high setting, such as 120. Under most circumstances, this keeps the printer ready to
print with minimum warm-up time. However, a high setting also uses more energy.
print with minimum warm-up time. However, a high setting also uses more energy.
Set
Power Saver
to
1
to put the printer in Power Saver mode one minute after it finishes a print job. This uses much less
energy, but requires more warm-up time for the printer. If your printer shares an electrical circuit with room lighting and you
notice lights flickering, you may want to set
notice lights flickering, you may want to set
Power Saver
to
1
.
If you want a balance between energy consumption and a shorter warm-up period, select a
Power Saver
value between 1 and
120 minutes.
*Factory default