Plextor px-504a Manual De Usuario
Section 2. Installing Your PX-504A
PX-504A Installation and Users Manual
15
Before PX-504A Installation
How to Install the PX-504A
D System uses special Cable Select
cables; all devices are jumpered for
Cable Select.
Cable Select.
Set the PX-504A’s mode jumper to
CSEL, and connect the drive to the
end of the cable from the computer’s
IDE interface connector.
CSEL, and connect the drive to the
end of the cable from the computer’s
IDE interface connector.
Figure 9: How to Install the PX-504A If Your Computer Is Originally Set Up in
Configuration D
About Cable Select
The Cable Select jumper position sets the PX-504A drive to use the CSEL signal
from the IDE interface for configuration purposes. This signal automatically selects
the correct Master/Slave setting for the drive.
from the IDE interface for configuration purposes. This signal automatically selects
the correct Master/Slave setting for the drive.
Figure 10: Configuring the PX-504A Drive for Cable Select
To use CSEL, you must have:
• A computer that supports CSEL.
• A special CSEL (Cable Select) cable for IDE.