KitchenAid Torrent™ Magnetic Drive Blender Uso Y Cuidado

If the problem cannot be fixed with the steps provided in this section, contact an authorized 

service center (see “Warranty and service” section). 

•  Power Loss - Rotate selection dial to 

the “OFF/O” position and then rotate to 

desired selection setting and press  

START/PAUSE.  

•  The Blender automatically shuts off after 

approximately 2 minutes of blending 

on Variable Speed. To reset it, turn the 

selection dial to the “OFF/O” position, 

and then back to your desired setting, and 

press START/PAUSE.

•  The Blender may be jammed. If it is 

jammed, the Blender will stop running  

to avoid damage to the motor. Rotate the 

knob to “OFF/O”, then unplug the power 

cord. Remove the pitcher from the base, 

and with a scraper, free the blades by 

breaking up or removing the contents  

at the bottom of the pitcher. To restart, 

rotate the knob to “OFF/O” position and  

then rotate to knob selection and press 

START/PAUSE. 

•  If the LED is flashing on/off in rapid bursts, 

the pitcher might not be fully in place or 

the Blender might have gone into “sleep 

mode” and need to be reset to “OFF/O”. 

Follow the “Error mode” instructions.  

•  Check to see if the Blender is plugged 

into a grounded 3-prong outlet. If it is, 

press START/PAUSE; then unplug the 

Blender. Plug it back in to the same outlet, 

and press START/PAUSE. If the Blender 

still does not work, check the fuse or 

circuit breaker on the electrical circuit the 

Blender is connected to and make sure 

the circuit is closed.

•  The pitcher might not be fully in place. 

Ensure it is all the way in and the lid  

is aligned. 

•  The Blender may need to be reset.  

Turn it to the “OFF/O” position and back  

to your desired setting.

W10679580A_EN_v14.indd   14

12/15/14   4:35 PM