KitchenAid 30-Inch 4 Element Induction Cooktop, Architect® Series II Guía De Instalación

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

■

Brackets (2)

■

2

¹⁄₂" (6.4 cm) clamping screws (4)

■

#8 x 

³⁄₈" (9.5 mm) sheet metal screws (4)

■

A UL listed or CSA approved strain relief

■

UL listed wire connectors

■

A UL approved junction box or 240V outlet

■

Cooktop Bracket Adhesive Kit Part Number W10310006 if 
installing the cooktop into a marble countertop. See the 
“Assistance or Service” section of the Use and Care Guide 
for information on ordering.

Check local codes. Check existing electrical supply. See 
“Electrical Requirements.”

It is recommended that all electrical connections be made by a 
licensed, qualified electrical installer.

Make sure you have everything needed for correct installation. It 
is the responsibility of the installer to comply with the installation 
clearances specified in these instructions.

IMPORTANT: Observe all governing codes and ordinances. 
When installing cooktop, use minimum dimensions given.

■

To eliminate the risk of burns or fire by reaching over the 
heated surface units, cabinet storage space located above 
the surface units should be avoided. If cabinet storage is to 
be provided, the risk can be reduced by installing a range 
hood that projects horizontally a minimum of 5" (12.7 cm) 
beyond the bottom of the cabinets.

■

It is the installer’s responsibility to comply with installation 
clearances specified on the model/serial rating plate. The 
model/serial rating plate is located on the underside of the 
cooktop burner box.

■

Check the cooktop base for an approved installation label. 
Verify approved oven model numbers that can be installed 
with your cooktop model number. If you do not find this label, 
your cooktop may not be approved for use over an 
undercounter built-in oven. Contact your dealer to confirm 
that your cooktop is approved.

■

Ovens approved for this type of installation will have an 
approval label located on the top of the oven. If you do not 
find this label, contact your dealer to confirm that your oven is 
approved. Refer to oven manufacturer’s Installation 
Instructions for approval for built-in undercounter use and 
proper cutout dimensions.

■

When installing cooktop over an undercounter built-in oven, 
do not fasten cooktop to countertop with clamps or seal 
cooktop to countertop. This will make the cooktop easier to 
remove if future servicing becomes necessary.

■

Use the countertop opening dimensions that are given with 
these Installation Instructions. Given dimensions are 
minimum clearances and provide 0" (0 cm) clearance.

■

Grounded electrical supply is required. See “Electrical 
Requirements” section.

■

Tape measure

■

Flat-blade screwdriver

■

Phillips head screwdriver

■

Hand or electric drill

■

Level

■

Marker or pencil

■

Pliers

■

¼" drill bit

■

Jigsaw

A

A