KitchenAid 30-Inch 4 Burner Gas Rangetop, Commercial-Style Guía De Instalación

6.  Place LP gas orifice spuds in plastic parts bag for future use 

and keep with package containing literature.
NOTE: There may be extra orifices in your kit.

7.  Replace the burner base.
8.  Replace burner cap.
9.  Repeat steps 2 through 8 for the remaining burners.

1.  Remove grill grate, wave plate, flame spreader and burner 

assembly. See the “Install Grill Grease Trays” section for 

removal instructions. Set parts aside.

2.  Use a 

1

/

2

" deep-well socket to remove the LP gas orifice 

hood. Replace with correct grill Natural gas orifice hood. 

See the “Natural Gas Orifice Spud/Hood Chart.”

3.  Turn Natural gas orifice hood down tightly onto orifice base.
4.  Place LP gas orifice hoods in plastic parts bag for future use 

and keep with package containing literature.

5.  Before replacing the burner assembly, loosen the screw at 

the front of the burner and rotate the shutter so that the 

opening is 

3

/

8

" (9.0 mm) wide.

6.  Reinstall the burner assembly, flame spreader, wave plate, 

and grill grate. See the “Install Grill Grease Trays” section for 

installation instructions.

7.  Open shut-off valve in the gas supply line. The valve is open 

when the handle is parallel to the gas pipe.
REMEMBER: Once you have completed converting the 

grill, test the cooktop for leaks by brushing on an approved 

noncorrosive leak-detection solution. Bubbles will show, 

indicating a leak. Correct any leaks found.

8.  Plug in cooktop or reconnect power.

1.  Refer to the “Make Gas Connection” section for properly 

connecting the cooktop to the gas supply.

2.  Refer to the “Electronic Ignition System” section for proper 

burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the Lo setting for each 

cooktop burner.
Checking for proper cooktop burner flame is very important. 

The small inner cone should have a very distinct blue flame 

1

/

4

" (0.64 cm) to 

1

/

2

" (1.3 cm) long. The outer cone is not 

as distinct as the inner cone. LP gas flames have a slightly 

yellow tip.

3.  Refer to “Complete Installation” in the “Installation 

Instructions” section of this manual to complete this 

procedure.