KitchenAid 24" Stainless Steel Refrigerator/Freezer Drawer Uso Y Cuidado

NOTE: If the Over Temp Alarm activates, your food may spoil. 
See “Power Interruptions.” Minimize opening of drawers until 
temperatures return to normal.
The Over Temperature feature is designed to let you know when 
either the refrigerator drawer temperature rises above 45°F (7°C) 
or the freezer drawer temperature rises above 6°F (-14°C) for 
4 hours or longer. The audio alarm will shut off automatically 
when the temperature returns to normal. To let you know an Over 
Temperature condition occurred, the indicator light will continue 
to flash until the Reset Alarm touch pad is pressed.

If the over temperature condition is still present when an Over 
Temp reset is performed, the indicator light will continue to 
reactivate every 4 hours until refrigerator and freezer 
temperatures are below 45°F (7°C) and 15°F (-9°C), respectively.
NOTE: These features will not appear on your control unless your 
refrigerator is over temperature and the alarm requires a reset.

This mode is used only when the refrigerator is on display in a 
retail store. If you unintentionally turn on Showroom Mode, Cool 
Off will light up on the display, and the controls will appear to 
work. Exit Showroom Mode by pressing and holding COOL ON 
and SABBATH at the same time for 3 seconds.

Ice Maker and 

Water Filtration System

 (Refrigerator/Freezer Drawers Only)

IMPORTANT: After connecting the refrigerator to a water source 
or replacing the water filter, fill and discard three full containers of 
ice to prepare the water filter for use before using ice. 

IMPORTANT: Use the Icemaker touch pad on the control panel 
to turn on or off the ice maker. Do not adjust the wire arm located 
on the ice maker.

■

Press the ICEMAKER touch pad to turn on the ice maker. The 
indicator light will illuminate when On.

■

Press the ICEMAKER touch pad to turn off the ice maker.

■

Allow 24 hours to produce the first batch of ice.

■

The quality of your ice will only be as good as the quality of 
the water supplied to your ice maker. 

■

Avoid connecting the ice maker to a softened water supply. 
Water softener chemicals (such as salt) can damage parts of 
the ice maker and lead to poor quality ice. If a softened water 
supply cannot be avoided, make sure the water softener is 
operating properly and is well maintained.

■

Do not store anything in the ice storage bin.

The water filter indicator light will help you know when to change 
your water filter. The indicator light will change from dark to 
yellow when it is time to order a new filter. 

The indicator light will then change from yellow to red when it is 
time to replace the water filter.

The disposable water filter should be replaced at least every 
6 months. After replacing the water filter, reset the water filter 
indicator.

■

Press and hold RESET FILTER for 3 seconds. The indicator 
light will turn Off.

NOTE: These features will not appear on your control unless you 
need to order or replace your filter.

The water filter is located through the base grille. You do not have 
to remove the base grille in order to change the water filter. 
1. Locate the water filter cap in the front base grille. Rotate the 

cap counterclockwise to a vertical position and pull the cap 
and water filter out through the base grille.
NOTE: There will be water in the filter. Some spilling may 
occur. 

2. Remove the filter cap by sliding it off the end of the old filter. 

The cap will slide to the left or right. 
IMPORTANT: Do not discard the cap. It is part of your 
refrigerator. Keep the cap to use with the replacement filter.   

Do not use with water that is microbiologically unsafe or of 
unknown quality without adequate disinfection before or 
after the system.