Craftsman SM1852RC Manual De Usuario
2
3
PRODUCT SPECIFICATIONS
MOTOR:
Power Source ........................................ 120V AC, 60 Hz, 9 Amp
Speed .................................................... 5000 RPM (No load)
Electric Brake ........................................ Yes
Double Insulated ................................... Yes
BLADE:
Diameter ................................................ 7-1/4 in.
Arbor Hole ............................................. 5/8 in.
MITER SAW
Rotating table:
Miter Detent Stops ................................. 0°, 15°, 22.5°, 31.6°, 45° Right & Left
Bevel Positive Stops .............................. 0°, 45° Left
Bevel Positive Stops .............................. 0°, 45° Left
Cutting capacity:
Crosscut ............................................... 2 in. x 8 in.
Miter 45° Right & Left ............................ 2 in. x 6 in.
Bevel 45° Left ........................................ 1-1/2 in. x 8 in.
45° Miter and 45° Bevel Left ................. 1-1/2 in. x 6 in.
Crown Molding Nested .......................... 3-1/4 in.
Base Molding Against Fence ................. 3 in.
To avoid electrical hazards, fire hazards or damage to the tool, use proper
circuit protection. This tool is wired at the factory for 110-120 Volt operation.
It must be connected to a 110-120 Volt / 9 Ampere time delay fuse or circuit
breaker. To avoid shock or fire, replace power cord immediately if it is worn,
cut or damaged in any way. Before using your tool, it is critical that you read
and understand these safety rules. Failure to follow these rules could result
in serious injury to you or damage to the tool.
WARNING
!