Craftsman SM2509RC Manual De Usuario
18
19
18
19
ASSEMBLY
To avoid injury, do not connect this
miter saw to the power source until
it is completely assembled and
adjusted and you have read and
understood this Operator’s Manual.
RELEASING CUTTING HEAD (FIG. A)
Raising
1. Push down slightly on the trigger
switch handle (1).
2. Pull out the hold-down latch (2).
3. Raise the cutting head to the
uppermost position.
NOTE: This cutting head is spring
loaded.
To avoid injury and damage to the
saw, transport and store the miter
saw with the cutting head locked
in the down position. Never use
the stop latch to hold the cutting
head in a down position for cutting
operations.
Locking
When transporting or storing the miter
saw, the cutting head should always be
locked in the down position.
WARNING
!
1. Push the cutting head down.
2. Press the hold-down latch (2) in
to lock.
IMPORTANT: To avoid damage, never
carry the miter saw by the trigger
switch handle or the cutting arm.
INSTALLING THE DUST BAG (FIG. B)
1. Install the dust bag assembly (1)
onto the exhaust port (2) on the
miter saw. Fit the connecting tube of
dust bag assembly and the exhaust
port together.
NOTE:
●
The dust bag assembly should be
angled toward the right side of the
saw for best results. This will also
avoid any interference during the
saw operation.
● T
o empty the dust bag, pull out the
dust bag assembly from exhaust
port. Open zipper on underside of
bag and empty into waste container.
IMPORTANT: Check frequently and
empty bag before it gets full.
Do not use this saw to cut and/or sand
metals. The hot chips or sparks may
ignite sawdust from the bag material.
Fig. A
Fig. B
WARNING
!
WARNING
!
1
2
1
2