Craftsman 11375 Manual De Usuario
Battery Packs
Item Nos.
9
11068 (12 Volt)
9
11044 (14.4 Volt)
9
11045 (18 Volt)
9
11375 (19.2 Volt)
CHARGER SOLD SEPARATELY
Always mention the above item numbers when communi-
cating with us regarding battery packs.
Use battery packs for Craftsman Cordless products only.
Use battery packs for Craftsman Cordless products only.
Refer to the Operator’s Manual provided with product.
These battery packs require 1 hour of charging time to be
These battery packs require 1 hour of charging time to be
fully charged.
Use batteries only with chargers listed.
mODEL nO.
bATTERY PACK
CHARGER
315.110680
130279001
Item No.
9
11068
1425301
Item No.
9
11041
315.110441
130279002
Item No.
9
11044
1425301
Item No.
9
11041
315.110451
130279004
Item No.
9
11045
1425301
Item No.
9
11041
315.113753 130279003, 130279005
Item No.
9
11375
1425301
Item No.
9
11041
batteries vent hydrogen gas and can explode in the
presence of a source of ignition, such as a pilot light.
To reduce the risk of serious personal injury, never use
any cordless product in the presence of open flame. An
exploded battery can propel debris and chemicals. If
exposed, flush with water immediately.
Do not charge battery in a damp or wet location.
Following this rule will reduce the risk of electric shock.
For best results, your battery should be charged in a
location where the temperature is more than 50°F but
less than 100°F. Do not store outside or in vehicles.
Save these instructions. Refer to them frequently
and use them to instruct others who may use this
tool. If you loan someone this tool, loan them these in-
structions also to prevent misuse of the product and
possible injury.
WARnInG!
Read all instructions. Failure to follow
all instructions listed below may result in electric
shock, fire and/or serious injury. The term “power
tool” in all of the warnings listed below refers to your
mains-operated (corded) power tool or battery-oper-
ated (cordless) power tool.
Ensure the switch is in the off position before inserting
battery pack. Inserting the battery pack into power tools
that have the switch on invites accidents.
Recharge only with the charger specified by the manu-
facturer. A charger that is suitable for one type of battery
pack may create a risk of fire when used with another bat-
tery pack.
Use power tools only with specifically designated bat-
tery packs. Use of any other battery packs may create a
risk of injury and fire.
Do not place battery tools or their batteries near fire
or heat. This will reduce the risk of explosion and possibly
injury.
never use a battery that has been dropped or
received a sharp blow. A damaged battery is subject to
explosion. Properly dispose of a dropped or damaged
battery immediately.
When battery pack is not in use, keep it away from
other metal objects like paper clips, coins, keys, nails,
screws, or other small metal objects that can make a
connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
Under abusive conditions, liquid may be ejected from
the battery, avoid contact. If contact accidentally oc-
curs, flush with water. If liquid contacts eyes, addition-
ally seek medical help. Liquid ejected from the battery
may cause irritation or burns.
CHARGInG THE bATTERY PACK
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge it
until the green LED on the front of the charger comes on.
nOTE: Batteries will not reach full charge the first time they
nOTE: Batteries will not reach full charge the first time they
are charged. Allow several cycles (operation followed by
recharging) for them to become fully charged.
recharging) for them to become fully charged.
CHARGInG A COOL bATTERY PACK
If battery pack is below normal temperature range, the green
LED on charger will come on. Allow battery pack to reach
normal temperature, then the red LED will come on.
nOTE: If the charger does not charge the battery pack
nOTE: If the charger does not charge the battery pack
under normal circumstances, return both the battery pack
and charger to your nearest authorized service center for
electrical check.
Charge the battery pack only with the charger provided.
Make sure the power supply is normal household
voltage,
120 volts, 60 Hz, AC only.
Connect the charger to the power supply.
Place the battery pack in the charger aligning raised rib
on the battery pack with the groove in the charger.
See
Figure 1.
Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
Normally the red LED on charger will come on. This
indicates the charger is in fast charging mode.
SAFETY RULES
OPERATIOn