Craftsman 30381 Manual De Usuario

5 ― English

■ Make sure your extension cord is in good 

condition. When using an extension cord, be 

sure to use one heavy enough to carry the 

current your product will draw. A wire gauge 

size (A.W.G.) of at least 14 is recommended 

for an extension cord 50 feet or less in length. 

If in doubt, use the next heavier gauge. The 

smaller the gauge number, the heavier the 

cord. An undersized cord will cause a drop 

in line voltage resulting in loss of power and 

overheating.
■ Do not point the blower nozzle in the 

direction of people or pets.
■ Never place blower on any surface, except 

a hard, clean surface when motor is running. 

Gravel, sand, and other debris can be picked 

up by the air inlet and thrown at the operator 

or bystanders, causing possible serious 

injuries.
■ Never run the unit without the proper 

equipment attached. Always ensure the 

blower tubes are installed.
■ When not in use, blower should be stored 

indoors in a dry, locked up place - out of the 

reach of children.

■ Maintain tool with care. Keep fan area 

clean for best and safest performance. Follow 

instructions for proper maintenance.
■ Do not attempt to clear clogs from tool 

without first unplugging it.
■ Do not pull or carry by cord, use cord as 

a handle, or pull cord around sharp edges 

or corners. Keep cord away from heated 

surfaces.
■ Do not unplug by pulling on cord. To 

unplug, grasp the plug, not the cord.
■ If the power supply cord is damaged, stop 

using the unit.Take the unit to a qualified 

service dealer for inspection and possible 

repair. 

■

Save these 

instructions.

 

Refer to them frequently and use them to 

instruct others who may use this power tool. 

If you loan someone this power tool, loan 

them these instructions also.