Craftsman SM2511RC Manual De Usuario

Craftsman

26

27

ADJUSTMENTS

BEVEL STOP ADJUSTMENT

To avoid injury from an accidental

start, make sure the switch is in the

OFF position and the plug is not

connected to the power source.

90° (0°) Bevel Adjustment (Fig. O)

1. Loosen bevel lock knob (1) and

tilt the cutting arm completely to

the right. Tighten the bevel lock

knob (1).

2. Place a combination square (2) on

the miter table (3) with the ruler

against the table and the heel of the

square against the saw blade.

3. If the blade is not 90°(0°) square

with the miter table (3), loosen the

bevel lock knob (1), tilt the cutting

head to the left, loosen the

locknut (4) on the bevel angle

adjustment bolt (5) and use a

10 mm wrench to adjust the bevel

angle adjustment bolt (5) depth in

or out to increase or decrease the

bevel angle.

4. Tilt the cutting arm back to the right

at 90°(0°) bevel and recheck for

alignment.

5. Repeat steps 1 through 4 if further

adjustment is needed.

6. Tighten bevel lock knob (1) and

locknut (4) when alignment is

achieved.

WARNING

!

Fig. O

90° Bevel Pointer Adjustment (Fig. P)

1. When the blade is exactly 90°(0°) to

the table, loosen the bevel pointer

screw (6) using a # 2 Phillips

screwdriver.

2. Adjust bevel pointer (7) to the “0”

mark on the bevel scale and

retighten the screw (6).

Fig. P

2

3

1

5
4

8

6

7