Cisco Cisco MGX 8800 8900 Series Route Processor Module Hoja De Datos
Data Sheet
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Page 1 of 6
Cisco Route Processor Module XF
The Cisco
®
Route Processor Module XF (RPM-XF) is a high-performance integrated
IP/Multiprotocol Label Switching (MPLS) services for the Cisco MGX
®
8880 Media Gateway, Cisco
MGX 8950 Multiservice Switch, and Cisco MGX 8800 Series Multiservice Switches. Its Cisco
Parallel Express Forwarding (PXF) adaptive processor provides low latency through hardware-
based forwarding for flexible service delivery in conjunction with Cisco IOS
®
Software. The Cisco
RPM-XF enables the switch to provide high-performance IP/MPLS-based VPN and quality-of-
service (QoS) services along with ATM and other multiservice capabilities. This enables the MGX
to offer Layer 3 services as well as enable migration from Layer 2 to Layer 3 networks. The Cisco
RPM-XF is used by small and large Cable, Wireline, and Wireless Service providers as well as
enterprise customers.
Applications
●
IP/MPLS-enabled multiservice networks for service provider and enterprise networks
●
Differentiated IP Radio Access Network (IPRAN) voice and data service aggregation using
MLPPP protocol
●
Voice-over-IP (VoIP) services with minimal latency and without service interruption due to
failure
●
Support for IPv4 Multicast and Multicast VPN
●
Bandwidth savings through Routing Table Protocol (RTP) header compression for IP
services
●
New IP Next-Generation Network converged wireline and wireless services