Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) Guía Para Resolver Problemas
Configure EtherChannel Using an ML Card on ONS
15454 and Catalyst Switch Across RPR
15454 and Catalyst Switch Across RPR
Document ID: 69342
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Network Diagram
Configuration
Configuring RPR
Configuring EtherChannel
Verification
Related Information
Prerequisites
Requirements
Components Used
Conventions
Network Diagram
Configuration
Configuring RPR
Configuring EtherChannel
Verification
Related Information
Introduction
This documentdescribes the procedure to configure EtherChannel and 802.1Q tunneling using a Cisco
Catalyst 3500XL switch and the ML−Series card across the Resilient Packet Ring (RPR) in an Cisco ONS
15454 environment.
Catalyst 3500XL switch and the ML−Series card across the Resilient Packet Ring (RPR) in an Cisco ONS
15454 environment.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco ONS 15454
•
Cisco ONS 15454 ML−Series Ethernet Cards
•
Catalyst 3500XL switch
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco ONS 15454 Version 6.x
•
Catalyst 3500XL switch that runs Cisco IOS® Software Release 12.0(5)XC
•
ML (bundled as part of the ONS 15454 6.0 release) that runs Cisco IOS® Software Release
12.2(27)SV and later
12.2(27)SV and later
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.