Cisco Cisco Wireless LAN Controller Module Manual Técnica

Introduction
 Prerequisites
      Requirements
      Components Used
      Guidelines and Limitations for Using Workgroup Bridges in a Lightweight Environment
      Conventions
 Workgroup Bridge in a Cisco Unified Wireless Network
      Passive Clients Behind a WGB
 Configure
      Network Diagram
      How to Configure the Workgroup Bridge

How to Configure the Wireless LAN Controller (WLC)
Verify and Troubleshoot
      Verify
      Troubleshoot
 Related Information

This document provides an example for the configuration of Cisco Autonomous IOS

®

 access points to operate

in Workgroup Bridge (WGB) mode and connect to a Cisco Unified wireless network.

Ensure that you meet these requirements before you attempt this configuration:

Knowledge of Cisco Autonomous solution and Cisco IOS−based Access Points

• 

Knowledge of Lightweight Access Point Protocol (LWAPP)

• 

The information in this document is based on these software and hardware versions:

Cisco 1231G AP that runs Cisco IOS Software Release 12.3 (8)JEC

• 

Cisco 4400 WLC that runs version 4.2

• 

Cisco 1130 series Light Weight AP

• 

The WGB can be any Cisco Autonomous Access Point that supports the Workgroup Bridge mode and runs
Cisco IOS Software Release 12.4(3g)JA or later (on 32−MB access points) or Cisco IOS Software Release
12.3(8)JEB or later (on 16−MB access points). These access points include the AP1120, AP1121, AP1130,
AP1231, AP1240, and AP1310. Cisco IOS software releases prior to Cisco IOS Software Releases 12.4(3g)JA