Cisco Cisco Wireless LAN Controller Module Manual Técnica
Ethernet Bridging in Point−Point Wireless Mesh
Network Configuration Example
Network Configuration Example
Document ID: 99862
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
Assign IP Address to the APs
Add the MAC Address of APs to the MAC Filtering List of the WLC
Register the AP with the WLC
Configure the AP Role and Other Bridging Parameters
Enable Ethernet Bridging on the APs
Enable Zero−Touch Configuration on the WLC
Verify
Troubleshoot
Troubleshooting Commands
Related Information
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
Assign IP Address to the APs
Add the MAC Address of APs to the MAC Filtering List of the WLC
Register the AP with the WLC
Configure the AP Role and Other Bridging Parameters
Enable Ethernet Bridging on the APs
Enable Zero−Touch Configuration on the WLC
Verify
Troubleshoot
Troubleshooting Commands
Related Information
Introduction
This document provides a simple configuration example for how to configure Ethernet bridging on an outdoor
wireless mesh network. This document explains point−to−point Ethernet bridging between the outdoor
wireless mesh access points (APs).
wireless mesh network. This document explains point−to−point Ethernet bridging between the outdoor
wireless mesh access points (APs).
Prerequisites
The wireless LAN controller (WLC) is configured for basic operation.
•
The WLC is configured in Layer 3 mode.
•
The switch for the WLC is configured.
•
Requirements
Ensure that you meet these requirements before you attempt this configuration:
Basic knowledge of the configuration of Lightweight Access Points (LAPs) and Cisco WLCs
•
Basic Knowledge on wireless mesh networking solution
•
Basic knowledge of Lightweight AP Protocol (LWAPP)
•
Basic configuration knowledge of Cisco switches
•
Components Used
The information in this document is based on these software and hardware versions: