Cisco Cisco Wireless LAN Controller Module Prospecto

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Background Information
      Cisco Aironet 1510 Series Lightweight Outdoor Mesh AP

Roof−top Access Point (RAP)
Pole−top Access Point (PAP)
      Features Not Supported on Mesh Networks
      Access Point Startup Sequence
 Configure
Enable Zero Touch Configuration (Enabled by Default)
      Add the MIC to the AP Authorization List
      Configure Bridging Parameters for the APs
 Verify
 Troubleshoot
      Troubleshooting Commands
 Related Information

This document provides a basic configuration example for how to establish a point−to−point bridged link
using the Mesh Network solution. This example uses two lightweight access point (LAPs). One LAP operates
as a roof−top access point (RAP), the other LAP operates as a pole−top access point (PAP), and they are
connected to a Cisco Wireless LAN (WLAN) Controller (WLC). The RAP is connected to the WLC through a
Cisco Catalyst switch.

Please refer to Wireless LAN Controller Mesh Network Configuration Example for Releases 5.2 and later for
WLC release 5.2 and later versions

The WLC is configured for basic operation.

• 

The WLC is configured in Layer 3 mode.

• 

The switch for the WLC is configured.

• 

Ensure that you meet these requirements before you attempt this configuration:

Basic knowledge of the configuration of LAPs and Cisco WLCs

• 

Basic knowledge of Lightweight AP Protocol (LWAPP).

•