Cisco Cisco Nexus 7000 Series Supervisor 1 Module Guía Para Resolver Problemas

Contents

Introduction

Prerequisites

Requirements

Components Used

Replace a Cisco Nexus 7000 Series Switch

Before You Begin

In the Implementation Window

Option 1. Phased Approach

Option 2. Direct Replacement

How to Ensure the vPC Sticky Bit is Set Correctly

Introduction

This document describes the steps needed to perform a chassis replacement in a Virtual Port
Channel (vPC) environment. This scenario occurs due to hardware failure or feature/hardware
support limitations.

Prerequisites

Requirements

Cisco recommends that you have knowledge of these topics:

Nexus operating system CLI

●

vPC rules

●

Components Used

The information in this document is based on these software and hardware versions:

Supervisor 1 Release 5.2(3a) or later

●

Supervisor 2 Release 6.x or later

●

The information in this document was created from the devices in a specific lab environment. All of
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.

Replace a Cisco Nexus 7000 Series Switch

When you replace a Cisco Nexus 7000 Series switch, you must perform this procedure in order to
ensure that there is minimal or no outage. This image illustrates how to replace the chassis.