Cisco Cisco Catalyst 3850 4x 10GE Network Module Manual Técnica

Introduction
 Prerequisites
      Requirements
      Components Used
      Related Products
      Conventions
 EtherSwitch Modules − Concepts
 Configure
      Network Diagram
      Configurations
      EtherSwitch Module Initial Configuration
      Configure VTP and VLAN
      Configure Spanning Tree, Trunk and Port Channel
      Configure Access Port
      Configure Voice Port
      Configure Routing
      Configure QoS
 Verify
 Troubleshoot
 Related Information

This document provides a sample configuration for the EtherSwitch Service module installed in the Integrated
Service Router (ISR). This document does not discuss the configuration example for the EtherSwitch Network
module.

There are no specific requirements for this document.

The information in this document is based on these software and hardware versions:

Cisco 2800 Series Router on Cisco IOS® Software Release 12.4(10)

• 

NME−16ES−1G−P − 16−port 10/100 Cisco EtherSwitch Service Module

• 

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.