Cisco Cisco Catalyst 3850 4x 10GE Network Module Manual Técnica
EtherSwitch Network Module (ESW) Configuration
Example
Example
Document ID: 82156
Contents
Introduction
Prerequisites
Requirements
Components Used
Related Products
Conventions
EtherSwitch Modules − Concepts
Configure
Network Diagram
Configurations
Configure VLAN Interfaces
Configure VTP, Trunk, Port Channel, and Spanning Tree
Configure Access Ports
Configure the Voice Port
Prerequisites
Requirements
Components Used
Related Products
Conventions
EtherSwitch Modules − Concepts
Configure
Network Diagram
Configurations
Configure VLAN Interfaces
Configure VTP, Trunk, Port Channel, and Spanning Tree
Configure Access Ports
Configure the Voice Port
Configure Quality of Service (QoS)
Verify
Troubleshoot
Related Information
Verify
Troubleshoot
Related Information
Introduction
This document provides a sample configuration for the EtherSwitch Network Module installed in the
Integrated Service Router (ISR). This document does not discuss the configuration example for EtherSwitch
Service Module.
Integrated Service Router (ISR). This document does not discuss the configuration example for EtherSwitch
Service Module.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software and hardware versions:
Cisco 2800 Series Router on Cisco IOS® Software Release 12.4 or later
•
NM−16ESW−PWR= 16 port 10/100 EtherSwitch Network Module (NM)
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.