Cisco Cisco Firepower Management Center 2000 Guía Del Desarrollador
Version 5.3
Sourcefire 3D System eStreamer Integration Guide
409
Configuring eStreamer
Configuring eStreamer on the eStreamer Server
Chapter 6
Using An Alternate Management Interface with eStreamer
L
ICENSE
: Any
By default, eStreamer uses the primary management interface,
eth0
to stream
data to eStreamer clients. You can configure eStreamer to use the any available
management interface. This example uses
eth1
, but you can use any available
management interface. eStreamer can only use one interface at a time.
To configure eStreamer to use an alternate management interface
A
CCESS
: Admin (escalated to Root)
1. Connect the
eth1
interface on the Defense Center to a broadcast domain
that is the same domain as the eStreamer clients and not the same domain
as the
eth0
interface.
WARNING!
Placing the
eth0
and
eth1
interfaces in the same broadcast
domain will impact performance.
2. Open an SSH connection to the Defense Center.
3. Log into the Defense Center.
3. Log into the Defense Center.
4. Type
sudo su
to get root access. If necessary, type your password again
when prompted.
5. Type the command
configure-network -i eth1 enable
to enable the
eth1
interface.
6. Configure the
eth1
interface using the prompts.
The following prompt appears:
Do you wish to configure IPv4? (y or n)
7. Type
y
and press Enter. If you do not type
y
, you will not be prompted to
configure IPv4 or IPv6.
The following prompt appears:
The following prompt appears:
Management IP address? [10.5.60.199]
8. Type the desired IP address and press Enter.
The following prompt appears:
Management netmask? [255.255.0.0]
9. Type the netmask and press Enter.
The following prompt appears:
Management default gateway? [10.5.1.1]
10. The default gateway is loaded from the
eth0
interface. You cannot set the
default gateway specifically for eStreamer.