Cisco Cisco AMP 7150 Guía Para Resolver Problemas
Contents
Introduction
Command Line Switches
Available Switches
Default Switches
Installation with Remote Deployment Tools
Installation Without Specification of a Switch
Unsupported Operating Systems
Introduction
This document provides a list of available switches in the Sourcefire FireAMP Connector Installer.
The Sourcefire FireAMP Connector Installer has built-in command line switches. You can use
them with a deployment software to automate FireAMP deployment.
The Sourcefire FireAMP Connector Installer has built-in command line switches. You can use
them with a deployment software to automate FireAMP deployment.
Caution: If your network is live, make sure that you understand the potential impact of any
command.
command.
Command Line Switches
Available Switches
Command Line Switch Command Description
Special Notes
/S
Used to put the installer into
silent mode.
silent mode.
This must be specified as the first
parameter.
parameter.
/desktopicon 0
Used to specify that a desktop
icon is not created.
icon is not created.
/desktopicon 1
Used to specify that a desktop
icon is created.
icon is created.
This is a default option.
/startmenu 0
Start Menu shortcuts are not
created.
created.
/startmenu 1
Start Menu shortcuts are
created.
created.
This is a default option. This screenshot
shows the shortcut on the Start Menu.
shows the shortcut on the Start Menu.
/contextmenu 0
Disables Scan Now from the