Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP)
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Configuring GE_XP, 10GE_XP, GE_XPE, and
10GE_XPE Cards Using PCLI
10GE_XPE Cards Using PCLI
Last Updated: April 27, 2011, OL-25022-01
This document explains how to provision GE_XP, 10GE_XP, GE_XPE, and 10GE_XPE cards using
Pseudo Command Line Interface (PCLI).
Pseudo Command Line Interface (PCLI).
Note
The procedures and tasks described in this document for the Cisco ONS 15454 platform is applicable to
the Cisco ONS 15454 M2 and Cisco ONS 15454 M6 platforms, unless noted otherwise.
the Cisco ONS 15454 M2 and Cisco ONS 15454 M6 platforms, unless noted otherwise.
Note
Unless otherwise specified, “ONS 15454” refers to both ANSI and ETSI shelf assemblies.
Before You Begin
Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15454 DWDM Troubleshooting Guide as necessary.
conditions. Refer to the Cisco ONS 15454 DWDM Troubleshooting Guide as necessary.
Caution
Provisioning TXP and MXP cards can be service affecting. You should make all changes during a
scheduled maintenance window.
scheduled maintenance window.
This section lists procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
•
.
•
•
.
•
.