Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guía De Instalación
Chapter 3 USRM Web Interface
136
4039132 Rev B
Parameter
Description
OverrideMacAddr
A MAC address used instead of the actual hardware
MAC address. Used when server hardware fails and is
replaced by a new unit.
MAC address. Used when server hardware fails and is
replaced by a new unit.
Note: You must be service level to modify this
parameter.
parameter.
STBCapacityAlarm
Threshold
Threshold
Displays the alarm threshold for the total number of
active STBs.
active STBs.
MaxServiceGroups
Displays the maximum number of service groups
supported by the software.
supported by the software.
ServiceGroupSTBCapacity
Displays the maximum number of STBs in a single
service group supported by the software.
service group supported by the software.
DisplayMode
Sets the web interface display mode, as follows:
Normal - Only populated entries in tables are displayed.
Config - All rows/entries of a table are displayed,
allowing you to enter values into the displayed rows for
configuration purposes. The server implements dynamic
rows that exist if configured. The Config mode exposes
all rows of a table allowing manual data entry into the
table. This technique is used to create an entry in a table.
allowing you to enter values into the displayed rows for
configuration purposes. The server implements dynamic
rows that exist if configured. The Config mode exposes
all rows of a table allowing manual data entry into the
table. This technique is used to create an entry in a table.
MaxQAMChannels
Displays the maximum number of QAM channels
supported by the software.
supported by the software.
MaxSupportedSessions
Displays the maximum number of sessions supported by
the software.
the software.
ConfigHashWidth
The software uses a hash table to quickly locate sessions.
This setting shows the compile-time hash table width.
This setting shows the compile-time hash table width.
SessionUdpPortMin
Minimum value for the assignment of UDP port numbers
on Gigabit input ports.
on Gigabit input ports.
SessionUdpPortMult
Multiplier used for the calculation of UDP port numbers.
SessionUdpPortMax
Minimum value for the assignment of UDP port numbers
on Gigabit input ports.
on Gigabit input ports.
ServerName
The name of the server. This name is used to form the
name of log files.
name of log files.
Note: This parameter must be populated if the
Applications.SdvSM.Activity log.ActivityLogFormat is
set to Comcast.
Applications.SdvSM.Activity log.ActivityLogFormat is
set to Comcast.