Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guía De Instalación
Chapter 4 Operation
356
78-4021139-01 Rev D
Note: This program does not use the Offered Program sources. It has its own
source(s) specified.
Service Group Section Example
For the following service groups:
For the following service groups:
Service Group 1192 uses Zone 4 programs
Service Group 1193 uses Zone 1 programs
Service Group 1203 uses Zone 3 programs
Service Group 1194 uses Zone 4 programs
The service group section of the file would appear as shown below:
ServiceGroupTable.Zone.SGID1192 4
ServiceGroupTable.Zone.SGID1193 1
ServiceGroupTable.Zone.SGID1203 3
ServiceGroupTable.Zone.SGID1194 4
To Remove Zone Programs
To remove a zone program, simply set the multicast IP address to 0.0.0.0.
If unique source-specific addresses are used for the zone being removed, we
If unique source-specific addresses are used for the zone being removed, we
recommend setting all ScrAddrX fields to n/a when removing a program from a
zone. This removes the zone program from the Offered Progs Zones table. You can
perform this step from either the webUI or the zone configuration file.
If the zone program to be removed was configured using the webUI, remove the
If the zone program to be removed was configured using the webUI, remove the
zone program as follows:
1 Access the Offered Progs Zones table.
2 Select the program to be removed.
3 Set the multicast IP address to 0.0.0.0.
4 Set any SrcAddrX addresses to n/a.
5 Click Commit Changes.
1 Access the Offered Progs Zones table.
2 Select the program to be removed.
3 Set the multicast IP address to 0.0.0.0.
4 Set any SrcAddrX addresses to n/a.
5 Click Commit Changes.