Cisco Cisco Firepower Management Center 2000
7-5
FireSIGHT System User Guide
Chapter 7 Setting Up an IPS Device
Configuring Inline Sets
Adding Inline Sets
License:
Protection
You can add inline sets from the Inline Sets tab of the Device Management page. You can also add inline
sets as you configure inline interfaces.
sets as you configure inline interfaces.
You can assign only inline interface pairs to an inline set. If you want to create an inline set before you
configure the inline interfaces on your managed devices, you can create an empty inline set and add
interfaces to it later.
configure the inline interfaces on your managed devices, you can create an empty inline set and add
interfaces to it later.
You can also add multiple interface pairs when your network uses asynchronous routing, as shown in the
following diagram.
following diagram.
Table 7-1
Inline Sets Table View Fields
Field
Description
Name
The name of the inline set.
Interface Pairs
A list of all pairs of inline interfaces assigned to the inline set. A pair is not
available when you disable either interface in the pair from the Interfaces tab.
available when you disable either interface in the pair from the Interfaces tab.
Bypass
The configured bypass mode of the inline set.