Samsung Blu-ray Home Entertainment System H7750 Manual De Usuario

- English

Settings

Network Setup

When you connect this product to a network, you

can use network based applications and functions

such as Smart Hub and BD-LIVE, and upgrade the

product's software through the network connection.

For more information about accessing and using

Internet services, see the Network Services chapter

of this manual on pages 43~50. Instructions for

configuring the network connection start below.

Configuring your Network Connection

If you didn't configure your network connection during

the initial settings procedure or you need to reset the

network connection, follow the directions below.

Before you begin, contact your Internet Service

Provider to find out if your IP address is static or

dynamic. If it is dynamic, and you have a wired

or wireless network, we recommend using the

Automatic configuration procedures described below.

If you are connecting to a wired network, connect the

product to your router using a LAN cable before you

start the configuration procedure.

To begin configuring your network connection, follow

these steps:
1. In the Home screen, select Settings, and then

press the

button.

2. Select Network, and then press the

button.

3. Select Network Settings, and then press the

button.

4. Go to the instructions for Wired networks

starting or the instructions for Wireless networks

starting on the next page.

Wired Network

Wired – Automatic

After following Steps 1 to 3 above:
1. In the Network Settings screen, change

Network type to Wired. Then, select Connect

and press the

button. The product detects

the wired connection, verifies the network

connection, and then connects to the network.

2. When it is done, highlight OK, and then press

button.

Wired - Manual

If you have a static IP address or the automatic

procedure does not work, you'll need to set the

Network Settings values manually.

After following Steps 1 to 3 above:
1. In the Network Settings screen, change

Network type to Wired. Then, select Connect

and press the

button.

The product searches for a network, and then

displays the connection failed message.

✎

If it is possible to connect the home cinema to

your network wirelessly, select Change Network

at this point, change the Network type to

Wireless, and then go to the instructions for

wireless networks on the next page.

Network Settings

Wired network connection failed.

MAC Address

xx:xx:xx:xx:xx:xx

IP Address

0. 0. 0. 0

Subnet Mask

0. 0. 0. 0

Gateway

0. 0. 0. 0

DNS Server

0. 0. 0. 0

unable to connect to the network. Try the following: check if your IP address is set

correctly in IP Settings. Contact your Internet service provider for more information.

Change Network

IP Settings

Retry

2. Use the :; buttons to select IP Settings,

and then press the

button. The IP Settings

screen appears.

3. Select the IP setting field, and then set it to

Enter manually.

4. Select a parameter to enter (IP Address, for

example), and then press

. Use the 78

buttons on the remote control to enter the

numbers for the parameter. Or use the Num

keypad to enter a parameter number. Press and

hold the 123 button until the Num pad appears on

the screen. When the Num pad appears, select a

number using the 78:; button and then press

the

button. Use the :; buttons on the

remote control to move from entry field to entry

field within a parameter. When done with one

parameter, press the

button.

5. Press the 7 or 8 button to move to another

parameter, and then enter the numbers for that

parameter following the instructions in Step 4.

6. Repeat Steps 4 and 5 until you have filled in all

parameters.