Canon pixma mp460 Manual De Usuario
104
Chapter 11
Troubleshooting
Paper feed roller is dirty.
Follow the steps described below to clean the paper feed rollers.
1. Ensure that the machine is turned ON and there is no paper loaded in
the machine.
2. Select <Roller cleaning> from <Maintenance>.
3. Select <Yes> on the Roller cleaning confirmation screen and then press
[OK].
The paper feed roller will rotate as it cleans.
4. Repeat this operation twice.
5. Load three or more sheets of A4/Letter-sized plain paper lengthways in
the Auto Sheet Feeder.
6. Select <Roller cleaning> from <Maintenance>.
7. Select <Yes> on the Roller cleaning confirmation screen and then press
[OK].
The paper that is loaded in the machine will feed through the machine and
be ejected.
8. Repeat Steps 5 to 7 three times.
1. Ensure that the machine is turned ON and there is no paper loaded in
the machine.
2. Select <Roller cleaning> from <Maintenance>.
3. Select <Yes> on the Roller cleaning confirmation screen and then press
[OK].
The paper feed roller will rotate as it cleans.
4. Repeat this operation twice.
5. Load three or more sheets of A4/Letter-sized plain paper lengthways in
the Auto Sheet Feeder.
6. Select <Roller cleaning> from <Maintenance>.
7. Select <Yes> on the Roller cleaning confirmation screen and then press
[OK].
The paper that is loaded in the machine will feed through the machine and
be ejected.
8. Repeat Steps 5 to 7 three times.
Inappropriate paper type is used.
z
Check to see if the paper you are printing on is too thick. See “Paper
Types You Cannot Use” on page 16.
Types You Cannot Use” on page 16.
z
Note that smudging may occur at the top and bottom edges of the
paper when using Borderless Printing. Ensure that the paper you are
using is compatible with Borderless Printing.
paper when using Borderless Printing. Ensure that the paper you are
using is compatible with Borderless Printing.
Thick paper is used.
When printing on thick paper, set the Paper Thickness Lever to the right.
This widens the gap between the FINE Cartridge and the paper. Try this
maneuver if the printed surface is scratched.
This widens the gap between the FINE Cartridge and the paper. Try this
maneuver if the printed surface is scratched.
Media is curled.
If all four corners or the printing surface of the paper is curled, the paper
may become dirty or may not feed properly. Use the paper after correcting
paper curl as follows.
1. Place the printing surface face up (A), and cover it with a sheet of non-
printing regular paper to avoid damaging the surface.
2. Roll up the paper in the direction opposite to the paper curl as per the
figure below.
may become dirty or may not feed properly. Use the paper after correcting
paper curl as follows.
1. Place the printing surface face up (A), and cover it with a sheet of non-
printing regular paper to avoid damaging the surface.
2. Roll up the paper in the direction opposite to the paper curl as per the
figure below.
3. Check the printing paper to confirm if the paper curl is eliminated to
within approximately 2 to 5mm / 0.08 to 0.2 in (B).
within approximately 2 to 5mm / 0.08 to 0.2 in (B).
It is recommended to print on curl-corrected paper one sheet at a time.
Cause
Action
(A)
(A)
(B)