Sony TCM-459V Manual De Usuario

Insert a cassette with the side to start playing facing
the cassette holder.

Adjust the tape playback speed.
Set SPEED CONTROL to:
SLOW (slow) to play back a tape slower.
Center position to playback a tape at normal speed.
FAST (fast) to playback a tape faster.

Press 

( PLAY then adjust the volume. There is a

raised dot to show the direction to turn down volume
beside VOL.

At the end of the tape, playback stops and the unit turns
off automatically.

Stop playback/stop

p STOP

fast forward or rewind

Pause playback

PAUSE c in the direction of the
arrow
To release pause playback, release
PAUSE c*.

Search forward

Press and hold 

) FF/CUE and

during playback (CUE)

release it at the point you want

Search backward

Press and hold 

0 REW/REVIEW

during playback

and release it at the point you want

(REVIEW)

Fast forward**

) FF/CUE during stop

Rewind**

0 REW/REVIEW during stop

Start recording

r REC

during playback

* PAUSE c will be also automatically released when p STOP

is pressed (stop-pause-release function).

** If you leave the unit after the tape has been wound or

rewound, the batteries will be consumed rapidly. Be sure to
depress 

p STOP.

(

p

0

)

Connect a microphone to the MIC jack. The raised dot
near the MIC jack identifies as the jack for a microphone,
not an earphone. Use a microphone of low impedance
(less than 3 kilohms) such as ECM-T115 (not supplied).
When using a plug-in-power system microphone, the
power to the microphone is supplied from this unit.

Note
When recording with an external microphone, the VOR system
may not work properly because of the difference in sensitivity.

Connect another equipment to the MIC jack using the
RK-G64HG connecting cord (not supplied).
(For TCM-36: For Japan use the RK-G64, not supplied)

z

On power
•Operate the unit only on 3V DC. For AC operation, use

the AC power adaptor recommended for the unit. Do
not use any other type. For battery operation, use two
size R6 (AA) batteries.

On the unit
•Do not leave the unit in a location near heat sources, or

in a place subject to direct sunlight, excessive dust or
mechanical shock.

•Should any solid object or liquid fall into the unit,

remove the batteries or disconnect the AC power
adaptor, and have the unit checked by qualified
personnel before operating it any further.

•Keep personal credit cards using magnetic coding or

spring-wound watches etc. away from the unit to
prevent possible damage from the magnet used for the
speaker.

•If the unit has not been used for a long time, set it in the

playback mode and warm it up for a few minutes
before inserting a tape.

On tapes longer than 90 minutes
We do not recommend the use of tapes longer than 90
minutes except for a long continuous recording or
playback. They are very thin and tend to be stretched
easily.

If you have any questions or problems concerning your
unit, please consult your nearest Sony dealer.

Should any problem persist after you have made these
checks, consult your nearest Sony dealer.
You cannot press 

r REC.

m The tab on the tape has been removed.

( PLAY.

m The tape has reached the end. Rewind the tape.

m The batteries have been inserted with incorrect

polarity.

m The batteries are weak.
m PAUSE c is slid in the direction of the arrow.
m The AC power adaptor or car battery cord is not

firmly connected.

m The batteries have been inserted, but

simultaneously the AC power adaptor is connected
and not to be done to the wall outlet.

m The earphone is plugged in.
m The volume is turned down completely.

m SPEED CONTROL is set at a point other than the

center.

m The volume is turned down completely.
m The batteries are weak.
m The heads are contaminated. See “Maintenance.”

m Connection is made incorrectly.
m The batteries are weak.
m The record/playback head is contaminated.
m For TCM-465V: Change the flat mic or pop-up mic.
m For TCM-459V: MIC SENS has been set to the

improper position when VOR function works.

m For TCM-465V/459V: VOR is set to ON. When you

do not use VOR, set it to OFF.

m The erase head is contaminated.
m Recording or erasing is being made using recorded

CrO

2

 (TYPE II) or metal (TYPE IV) tape.

2-track 1 channel monaural

250 - 6,300 Hz

Approx. 3.6 cm (1

7

⁄

16

 in.) dia.

300 mW (at 10 % harmonic distortion)

Microphone input jack (minijack) sensitivity 0.2 mV for
3 kilohms or lower impedance microphone

Earphone jack (minijack) for 8 - 300 ohms earphone

from +30% to –15%

• Two size R6 (AA) batteries (supplied to TCM-36 only):

3V DC

DC IN 3 V jack accepts:
• AC-E30M (TCM-36 only) or AC-E30HG AC power adaptor

(not supplied) suitable in the country where the unit is to be
used.

• Sony DCC-E230 car battery cord (not supplied) for use on

12 V car battery.

TCM-465V:

   Approx. 116 

×

 91 

×

 43mm (4

5

⁄

8

 

×

 3

5

⁄

8

 

×

 1

3

⁄

4

 in.)

TCM-459V/36:   Approx. 116 

×

 91 

×

 38mm (4

5

⁄

8

 

×

 3

5

⁄

8

 

×

 1

1

⁄

2

 in.)

TCM-465V:

   Approx. 200 g (7.1 oz.)

TCM-459V/36:   Approx. 195 g (6.9 oz.)

R6 (size AA) batteries (2) (TCM-36 only)

Design and specifications are subject to change without notice.

To clean the tape heads and path
Wipe the heads, pinch rollers, and the capstans with a
cotton swab moistened with alcohol every 10 hours of
use.

To clean the exterior
Use a soft cloth slightly moistened in water. Do not use
alcohol, benzine or thinner.