Siemens pocket 2011 tango Manual De Usuario
Operating in a telephone system
52
KAP16.FM5
18.7.99
Gigaset 2011 Tango: A30852-X1106-B307-2-7619
Operating in a telephone system
To be able to operate your Gigaset 2011 Tango in a tele-
phone system, you must first
1. switch off the "Automatic Attenuation" function,
2. check the signaling method,
3. enter the analog trunk or MSI,
4. enter the pause lengths after the analog trunk or MSI.
1. switch off the "Automatic Attenuation" function,
2. check the signaling method,
3. enter the analog trunk or MSI,
4. enter the pause lengths after the analog trunk or MSI.
Activating/deactivating the automatic attenuation function
Possible signaling method settings
The factory default setting for the signaling method is
DTMF/Flash 100 ms.
This may have to be changed to operate the device in tel-
ephone systems or in PSTNs in some countries.
Setting dial pulsing (DP) or dual-tone multifrequency signaling
(
t means: browse using x
,
confirm using u
)
.t Service
Call up the "Service" menu item.
#1 Start the setting procedure.
o
Enter the four-digit base code (factory default: "0000")
(➔ page 58).
u
4@@x
Switch off the automatic attenuation function (for opera-
tion behind telephone systems).
or
u
4@1x
Switch on the automatic attenuation function (for PSTN
connection).
REDIAL
SET
REDIAL
SET
Please also consult the instructions for use sup-
plied with your telephone system.
Z
OK
.t Service
Call up the "Service" menu item.
#1 Start the setting procedure.
o
Enter the four-digit base code (factory default: "0000")
(➔ page 58).
u
@33x
Set dial pulsing (DP).
or
u
@37 x
dual-tone multifrequency signaling DTMF/Flash 100 ms.
REDIAL
SET
REDIAL
SET