caddx nx-6 Manual

10

Step 1

Your system must be in the Disarmed state to change user codes.

Step 2

Press [

U

]-[5].

Step 3

Enter a “Master Arm/Disarm Code”.
NOTE: For partitioned systems, someone changing the code of
another person must have access to all or more partitions than
the user being changed.

Step 4

The 

ready light

 will flash.

Step 5

Enter the 2 digit “user number” (always enter 2 digit such as [0] - [3]
for user 3, or [1] - [2] for user 12).

Step 6

Enter the new four (4) or six (6) digit “user code”.
NOTE: To delete a user code, enter [

U

]-[

U

]-[

U

]-[

U

] for a 4-digit code,

or [

U

]-[

U

]-[

U

]-[

U

]-[

U

]-[

U

] for a 6-digit code.

Step 7

The 

ready light

 will flash indicating you are back at Step 4 above. If

the code is rejected, the sounder will beep 3 times.

Step 8

If another “user code” needs to be programmed, return to Step 5.

Step 9

Press  the  [#] key while the 

ready light

 is flashing to exit the User

Code Programming Mode.

Assign authority levels to users by following the steps below.  Assign user codes
before assigning authority levels.

Step 1

Press [

U

]-[6].

Step 2

Enter a  “Master Arm/Disarm Code”.
NOTE: Someone changing the authority of another person can
only add or remove partition authorization for partitions to
which they have access.

Step 3

The 

ready light

 will flash.

Step 4

Enter the 2 digit “user number” to be assigned authority (The 

ready

light

 is constant and the 

instant light

 will flash).

Step 5

Lights illuminated indicate the authority levels assigned to this code.
An explanation of the lights is listed below. You may toggle (turn
on/off) the authority level by pressing the number for that authority
level.