Craftsman 486.24219 Manual De Usuario

4

NOTE: On sweepers smaller than 42", use only five spring

tines.

•  Assemble a vinyl cap onto each end of the frame tube. 

See figure 1.

•  Assemble a /" washer, the wheel, another /" 

washer and the /" plain jam nut onto the 

1/2" x 3-1/2" hex bolt. See figure 2.

•  Insert the bolt through the welded bracket and 

assemble the /" nylock jam nut onto the bolt. Adjust 
the nuts so that there is no end play in the wheel and 
then tighten the nuts securely against the welded 
bracket. Make sure the wheel still turns freely. See 
figure 2.

Use this hole for
42" & 46" sweepers

Use this hole for
smaller sweepers

()  

7/6" Wrench

()  

/" Wrenches

()  

3/4" or Adjustable Wrenches

()  

Knife

•  Remove all parts and hardware packages from the 

carton. Lay out all parts and hardware and identify 
using the illustrations on pages 3 and 4.

•  Turn the frame assembly as shown in figure 1.
•  Assemble seven spring tines to the top of the frame 

tube. Use a 5/16" x 1-1/2" hex bolt, two 3/8" flat
washers and a 5/6" nylock nut for each spring tine. 
Place one 3/8" flat washer on top of the frame tube
and the second 3/8" flat washer on top of the spring
tine. See figure 1.

.  Spring Tines (7)
.  Frame Assembly
3.  Gauge Wheel