Mitsubishi t300 Manual De Usuario

AFETY

NFORMATION

XPOSURE

ADIO

REQUENCY

IGNALS

Your wireless handheld portable tele-

phone is a low power radio transmitter

and receiver. When it is ON, it receives and

also sends out radio frequency (RF)

signals.

In August 1996, the Federal Communica-

tions Commissions (FCC) adopted RF

exposure guidelines with safety levels for

hand-held wireless phones. These guide-

lines are consistent with the safety stan-

dards previously set by both U.S. and

international standards bodies:

*ANSI C95.1 (1992)

*NCRP Report 86 (1986)

*ICNIRP (1996)

*American National Standards Institute;

National Council on Radiation Protection and

Measurements; International Commission on

Non-Ionizing Radiation Protection

Those standards were based on compre-

hensive and periodic evaluations of the

relevant scientific literature. For example,

over 120 scientists, engineers, and physi-

cians from universities, government health

agencies, and industry reviewed the avail-

able body of research to develop the ANSI

Standard (C95.1).

The design of your phone complies with

the FCC guidelines (and those standards).

HIS

MODEL

PHONE

MEETS

THE

GOVERNMENT

’

REQUIREMENTS

FOR

EXPOSURE

RADIO

WAVES

Your wireless phone is a radio transmitter

and receiver. It is designed and manufac-

tured not to exceed the limits for exposure

to radiofrequency (RF) energy set by the

Federal Communications Commission of

the U.S. Government. These limits are part

of comprehensive guidelines and establish

permitted levels of RF energy for the

general population. The guidelines are

based on standards that were developed

by independent scientific organizations

through periodic and thorough evaluation

of scientific studies. The standards include

a substantial safety margin designed to

assure the safety of all persons, regardless

of age and health.

The exposure standard for wireless mobile

phones employs a unit of measurement

known as the Specific Absorption Rate, or

SAR. The SAR limit set by the FCC is 1.6

W/kg.* Tests for SAR are conducted using

standard operating positions accepted by

the FCC with the phone transmitting at its

highest certified power level in all tested

frequency bands. Although the SAR is

determined at the highest certified power

level, the actual SAR level of the phone

while operating can be well below the

maximum value. This is because the phone

is designed to operate at multiple power

levels so as to use only the power required

to reach the network. In general, the

closer you are to a wireless base station

antenna, the lower the power output.

Before a phone model is available for sale

to the public, it must be tested and certi-

fied to the FCC that it does not exceed the

limit established by the government-

adopted requirement for safe exposure.

The tests are performed in positions and

locations (e.g., at the ear and worn on the

body) as required by the FCC for each

model. The highest SAR value as reported

to the FCC for this model phone when

tested for use at the ear is 1.35 and when

worn on the body, as described in this user

guide, is 0.51. (Body-worn measurements

differ among phone models, depending

upon available accessories and FCC require-

ments.) While there may be differences

between the SAR levels of various phones

and at various positions, they all meet the

government requirement for safe exposure.

The FCC has granted an Equipment Autho-

rization for this model phone with all

reported SAR levels evaluated as in com-

pliance with the FCC RF exposure guide-

lines. SAR information on this model

phone is on file with the FCC and can be

found under the Display Grant section of

http://www.fcc.gov/oet/fccid after search-

ing on FCC ID BGB MT345.

Additional information on Specific Absorp-

tion Rates (SAR) can be found on the

Cellular Telecommunications Industry Asso-

ciation (CTIA) website at http://

www.phonefacts.net.

* In the United States and Canada, the

SAR limit for mobile phones used by the