Mitsubishi diamond pro 87txm Manual De Usuario

8

The monitor has the power management function which reduces the power consump-

tion of the monitor when not in use.  There are three reduced power level modes.

When the horizontal sync signal is off, after around 10 seconds the monitor is

switched to a stand-by mode.  When the monitor is in stand-by mode, the screen is

off and the power on indicator will blink for 0.5 seconds of On-time and 0.5 seconds

of Off-time.

After the horizontal sync signal is restored, the picture will be displayed immediately.

When the vertical sync signal is off, after about 10 seconds the monitor is switched

to a suspend mode which reduces the monitor power consumption to less than 15W.

When the monitor is in suspend mode, the screen is off and the power indicator will

blink for 2 seconds of On-time and 2 seconds of Off time.  After the vertical sync

signal is restored, the picture will be displayed within a few seconds.

When the horizontal sync signal and vertical sync signal are off, after about 10

seconds the monitor is switched to a power-off mode which reduces the monitor

power consumption to less  than the power consumed at suspend mode above.

When the monitor is in power-off mode, the screen is off, and the power indicator

will blink for 3 seconds of On-time and 1 second of Off-time.

After both the sync signals are restored, the picture will be displayed within several

seconds.

The monitor includes the DDC1 and DDC2B feature.  DDC(Display Data Channel) is a

communication channel over which the monitor automatically informs the host system

about its capabilities (e.g. each supported resolution with its corresponding timing).

DDC is routed through previously unused pins of the 15-pin VGA connector.  The

system will perform "Plug & Play" feature if both, monitor and host, implements the DDC

protocol.