Hitachi VM-E521A Manual De Usuario

Getting Started 

- 19 - 

slack or no dust adheres to it, etc. After making sure that there is no abnormality, reinsert the cassette. If 
TAPE reappears, see "Troubleshooting" on page 60. 

Slide the EJECT switch in the direction of the arrow. The cassette door opens automatically. Remove the 
cassette. 

Protect 8mm cassettes from accidental erasure by sliding the tab on the side of the cassette towards the opposite 
side until the tab is completely visible. Slide the tab in the opposite direction, until the tab disappears, to record on 
the cassette again. 

 

The linear time counter displays the tape run in hours, minutes, and seconds, helping you to keep track of how 
long you've been filming or time you have left to film before running out of tape. 
Turn the camcorder on to display the linear time counter. The linear time counter keeps track from when you load 
a cassette into the camcorder and clears to 0:00:00 when the cassette is ejected. 

 

The tape remaining display shows the remaining tape that can be used for recording and playback, using seven 
dashes. This feature is handy when recording since it lets you know how long you can record on the loaded tape. 
Insert a cassette into the camcorder and start recording or playback; 10 seconds later, the remaining tape will be 
displayed. When the cassette is ejected, the display will disappear. "

" is displayed for 10 seconds 

after the tape starts to run. 

 

Note: The tape remaining display appears 10 seconds after the tape starts to run. 
Note: When the remaining tape time becomes less than about three minutes, TAPE END flashes in the 
viewfinder.