Koss ms2010 Manual De Usuario

3

• Choose the mounting location where 

the unit will not interfere with the 
normal driving function of the driver.

• Before finally installing the unit, 

connect the wiring temporarily and 
make sure it is all connected up 
properly and the unit and the system 
work properly.

• Use only the parts included with the 

unit to ensure proper installation.
The use of  unauthorized parts can 
cause malfunctions.

• Consult with your nearest dealer if 

installation requires the drilling of holes
or other modifications of the vehicle.

• Install the unit where it does not get in

the driver’s way and cannot injure the
passenger if there is a sudden stop, 
like an emergency stop.

• If installation angle exceeds 30˚ from 

horizontal, the unit might not give its 
optimum performance.

• Avoid installing the unit where it would

be subject to high temperature, such 
as from direct sunlight, or from hot air,
from the heater, or where it would be 
subject to dust, dirt or excessive 
vibration.

DIN FRONT/REAR-MOUNT
This unit can be properly installed either
from “Front” (conventional DIN Front-
mount) or “Rear” (DIN Rear-mount
installation, utilizing threaded screw holes
at the sides of the unit chassis).
For details, refer to the following
illustrated installation methods.

30˚

Before installing the unit, please remove
the two screws as indicated.

If your vehicle is a Nissan or Toyota, follow
these mounting instructions.
Use the screw holes marked T (Toyota)
or N (Nissan) located on both sides of the
unit to fasten the unit to the factory radio
mounting brackets supplied with your
vehicle.

Take out screws before installation

Dashboard or
Console

Factory Radio
Mounting
Bracket

Hook

Screw

Screw

Side view showing
Screw Holes marked
T, N