Demco 10931 Manual De Usuario
11. Remove three bolts from windshield washer tank,
unplug wiring and hose, and set tank aside or tie off.
12. Remove tie down brackets from each side, three bolts
from each side, these will not be reused.
14. Drill two 5/16
holes, one through each center base
plate tabs. With blue
on each 3/8
self-tapping bolts, install through drilled holes.
R
15. Reinstall windshield washer tank.
16. Cut outside grill bar on facia by measuring from the
center bar as shown in picture. NOTE: Some
trimming maybe needed for base plate to pass
through.
trimming maybe needed for base plate to pass
through.
17. Reinstall facia, all hardware and headlights.
10-1/2”
12-1/4”
R
13. Slide base plate on passenger’s side first, then pivot
over driver’s side. Use three 12mm-1.25 x 35mm bolts
and 12 mm lock washers on passenger’s side using
blue
and 12 mm lock washers on passenger’s side using
blue
on all bolts. On driver’s side, use three
12mm-1.25 x 70mm bolts, 12mm lock washers, and put
three spacer bushings behind baseplate up against
frame. Push base plate back against vehicle so center
tabs of base plate are tight against vehicle. Tighten the
six 12mm bolts.
three spacer bushings behind baseplate up against
frame. Push base plate back against vehicle so center
tabs of base plate are tight against vehicle. Tighten the
six 12mm bolts.