fisher--paykel dd605 Manual De Usuario

599464 

11 

WARNING:  Only run this cycle if the DishDrawer™ is connected to the water 
supply. 
This level runs an 8 minute fast test cycle.  
Press POWER to skip Fast Test Cycle and advance to the next level. 
Press START/PAUSE to enter Fast Test cycle. 

 
Once Fast Test Cycle is selected the DishDrawer™ goes into standby mode 
and 8 minutes will be showing on the display.  The test cycle is started by 
pressing START/PAUSE, and the following components are run during the 8 
minute cycle that follows:- Lid motors, fill valve, wash motor, element, drain 
motor, drying fan. 
 
Press POWER to exit at any time. 

In this level the DishDrawer™ can be run continuously in any wash cycle.  

Once the cycle has finished, the DishDrawer™ automatically restarts the 

same wash cycle. 
Press POWER to skip Continuous Cycle.  As this is the last level, doing this 

will exit diagnostics. 

Press START/PAUSE to enter Continuous Cycle. 
 

Once selected, the LCD backlight flashes on and off to indicate the 

DishDrawer™ is in continuous cycle and the cycle starts straight away (for 

integrated and flat door models the LED above the start/pause button will be 

orange instead of green to indicate the DishDrawer™ is running in continuous 
cycle).  It will run the last cycle that had been selected prior to going into 
diagnostics mode. 

 
If it is desired to run a different cycle, exit diagnostics, turn the DishDrawer™ 

on as normal and select the cycle required.  Then turn the DishDrawer™ off 
again, re-enter diagnostics and restart the Continuous Cycle as above. 
 
Press POWER to Exit at any time.