Hitachi CP-A300NM Manual De Usuario

14

Setting up

Connecting to a power supply

1.

Put the connector of the power cord into the 
AC IN

 (AC inlet) of the projector.

2.

Firmly plug the power cord’s plug into the 
outlet. In a couple of seconds after the 
power supply connection, the POWER 
indicator will light up in steady orange.

►Please use extra caution when connecting the power cord, as 

incorrect or faulty connections may result in re and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, consult 
your dealer to get a new one.
• Only plug the power cord into an outlet whose voltage is matched to the power 
cord. The power outlet should be close to the projector and easily accessible. 
Remove the power cord for complete separation.
• Never modify the power cord. 

WARNING

Using the security bar and slot

A commercial anti-theft chain or wire up to 
10 mm in diameter can be attached to the 
security bar on the projector.
Also this product has the security slot for 
the Kensington lock. 
For details, see the manual of the security 
tool.

►Do not use the security bar and slot to prevent the projector 

from falling down, since it is not designed for it.

WARNING

►Do not place anti-theft chain or wire near the exhaust vents.  

It may become too hot. 

CAUTION

• The security bar and slot is not comprehensive theft prevention 

measures. It is intended to be used as supplemental theft prevention measure.

NOTE

Please remember that when the DIRECT POWER

 

ON function activated (

53), the connection of the 

power supply make the projector turn on.

Power cord

Security bar

Security slot

Anti-theft chain or wire