Gasngo R&D Ltd. RDR008 Manual De Usuario
34
Chapter 3 – Station Installation Manual
Figure 14: Plastic Strips on the back-part of the Reader
2. Assemble the Reader in the Insulator with the "Front Side" groove facing the inlet.
Figure 15: Assembling the Reader in the Insulator
3. Insert the battery with the connector into the battery’s pouch in the Insulator when the
connector is on the low end of the Reader.
Assembling the insulator with the Reader onto the nozzle
1. Remove the existing Insulator!
2. After inserting the Reader into the Insulator, slide the Insulator onto the nozzle.
3. If the nozzle is installed on the pump, cut the loop at the rear of the Insulator.
4. Tighten that cut loop around the nozzle and close it with a zip tie.