G-Tek Electronics Corporation MIP Manual De Usuario

USB driver files can be found on the utility CD provided 

in your package.

WIM (Wireless in Motion) is an application that helps you 

configure and use the MIP-100. The utility CD contains 

two versions of WIM, one for your PC and one for your 

PDA (Pocket PC only). Select the appropriate version of 

WIM from the utility CD and double-click Setup.exe. Fol-

low the instructions on the screen to install the soft-

ware. Refer to your PDA documentation for details about 

installing software on your PDA.

You can upgrade the firmware of the MIP-100 if 

required, from the PC using the USB cable. The follow-

ing files are needed to upgrade the firmware:

• Firmware file called bundle.bin

• Firmware application called uploader_usb.exe

Follow these instructions to upload the new firmware to 

the MIP-100:

1. Press the Volume down key before you turn on the 

MIP-100, and then press the reset key. The phone 

enters the USB download mode. A message titled 

Firmware upgrade (USB) appears on the screen.

2. Connect the MIP-100 to your PC using the USB 

cable. If you have not installed the USB drivers on 

your PC, you are prompted to install them now. 

3. Make a note of the COM port number being used 

for connecting the MIP-100 to the PC. This can be 

obtained by checking the Device Manager under 

System on your PC. The COM port number appears 

under the Ports item.

4. Open the command prompt, type uploader_usb.exe 

COM port number and press Enter to start the 

upload.