Controlled Electronic Management Systems Ltd S610MSCRM Manual De Usuario
S610S Manual - Hardware Installer Manual - Version 1.8
7
How to use an S610S reader
Swipe a card over the keypad area, then enter a keypad command or PIN if required to do so.
LED Card Response table
Green
Card Valid
Description
Flashing Green
Card Expiring
Consult System Admin to extend Card Expiry date
Amber
Wrong Zone
Wrong Time zone
Wrong Time zone
Passback failure
Wrong PIN
Wrong PIN
Door not in card holder’s Access Level.
Door is in Card Holders Access level but not Time Zone.
Door is in Card Holders Access level but not Time Zone.
Card holder must comply with site access policy.
Swipe again and enter correct PIN.
Swipe again and enter correct PIN.
Red – Invalid card
Flashing Red
Card error - retry
Card not in system
Card not in system
Card expired
Lost or Stolen Card
Lost or Stolen Card
Try again; if fault persists consult your system administrator.
Consult your system administrator or site security office.
Consult your system administrator or site security office.
Consult your system administrator or site security office.
Consult your system administrator or site security office.
Consult your system administrator or site security office.
1.1 Cabling requirements
Cable needed
Connector type
2 pair (Belden 8723) cable, DataA, DataB, GND and 12V
4 way JST – J15
6 pair (Belden 8723) maximum Inputs and
Outputs
Outputs
8 way JST – J6 and
6way socket – J12
6way socket – J12
2 pair (Belden 8723) power/comms to Exit reader
4 way JST – J5 to J5