Controlled Electronic Management Systems Ltd S610MSCRM Manual De Usuario
S610S Manual - Hardware Installer Manual - Version 1.8
41
Connection Diagram for Equipment mode
Please note the S610SP Pico Reader does not support a second read head.
An example of S610S PCB connections used for Equipment Mode.
The relay connections, Normally Open or Normally closed will be specific to the equipment being
controlled.
controlled.
An example of S610S PCB connections used for Equipment Mode.
The relay connections, e.g. Normally Open or Normally closed will be specific to the equipment
being controlled.
being controlled.
Note: Unless set otherwise the default relay states on a reader are Fail Safe.
• When power fails to a reader the Normally Open position becomes
in a Closed state.
When power is restored to the Reader the relay states become opposite to the legend
marked states on the PCB.
When power is restored to the Reader the relay states become opposite to the legend
marked states on the PCB.
• S610S readers equipment feedback inputs are 0 and 2.
AC2000 software settings for equipment mode
WORKSTATION APPLICATION –HOLDER RECORD
No additional Personnel/Card Holder application settings are required for a card holder to enable
equipment using an S610S reader in Equipment Enable mode.
equipment using an S610S reader in Equipment Enable mode.
WORKSTATION APPLICATION – ACCESS LEVELS
Any S610S reader set to Enable Equipment mode must be placed into an Access Level.
Any card holder enabling controlled equipment must be a member of that Access Level.
Any card holder enabling controlled equipment must be a member of that Access Level.
Equipment Mode; Input configuration
Any Equipment Enable reader inputs used will be set to Normal. See Chapters 12 and 13 of this
manual. If not used inputs 0 and 2 must be disabled.
manual. If not used inputs 0 and 2 must be disabled.