Symbol Technologies NP3010 Manual De Usuario

Descargar
Página de 1
Phone Features
·
 Three-line display
· Headset port
· Ear tone for call waiting/incoming call
· Ringer on/off switch
· Vibrating, visual and audio ring signals
· Volume control
· Call forwarding/transfer
· Redial key
· Roaming
· External calls using gateway
· Unidirectional broadcast message
· Paging
· Dial by name
· Speed dial/address book
· External serial port
· Caller ID
· Battery strength meter
· Signal strength meter
Alpha Keys
FCT Key:
((TBD??))
MENU Key: access set up.
RCL Key:
functions as a speed dial and redial key,
listing the last eight numbers dialed.
NAME Key: used to access the directory for dialing
by name.
CLR Key:
deletes previous entered characters. Press and 
hold for two seconds and entire entry deletes.
STO Key:
used to store numbers in the Recall function.
HOLD key: used to put the caller on hold, and call
waiting access.
Getting Started
The battery included with the NetVISION Phone needs to be charged. 
Charge the battery using the dual-slot charging cradle accompanying 
the Phone before engaging in continuous use.((Does the battery come 
attached and fully charged??))
Charging the Battery
The charging cradle allows users to charge the battery separately or 
while attached to the phone. The cradle recharges one battery at a time. 
For the quickest charge, remove the battery from the Phone and place in 
the rear slot of the cradle. The red LED indicator lights while the battery 
charges. The green LED indicator lights for a fully charged battery. 
Turning the Phone On
Press and hold SND until an image appears on the screen, about
two seconds.
Turning the Phone Off
Press and hold END until the screen clears, about three seconds.
Indicator Descriptions
The first screen of the NetVISION Phone displays the IP address assigned 
to the Phone. The second screen automatically appears after a few 
seconds and displays:
· the Phone user name at the top of the display
· the word Idle below the user name if the Phone has associated with a 
Spectrum24 (S24) access point (AP) or the words No Network if the 
Phone has not associated with an AP
· the signal strength icon on the left side of the display
· the battery strength icon on the right side of the display
· two telephone icons at the bottom representing the two available lines. 
The icons highlight when in use.
The second menu displays:
NV Phone
(Status)
Signal Strength
Lines
Battery Strength
For Warranty & Service 
Information, Call:
1-800-653-5350
Outside North America, contact 
your local Symbol representative
FCC Requirements
This device must operate in compliance with 
Federal Communications Commission (FCC) 
Rules and Regulations Parts 15. See FCC 
registration label (located on bottom of 
equipment) for FCC registration.
This equipment has been tested and found to 
comply with the limits for Class A or Class B 
digital device, pursuant to Part 15 of the FCC 
Rules. These limits are designed to provide 
reasonable protection against harmful 
interference when the equipment is operated in 
a commercial environment. This equipment 
generates, uses, and can radiate radio 
frequency energy and, if not installed and
used in accordance with the instruction manual, 
may cause harmful interference to radio com-
munications. Operation of this equipment in a 
residential area is likely to cause harmful
 
interference in which case the user will be 
required to correct the interference at his
own expense.
However, there is no guarantee that 
interference will not occur in a particular 
installation. If this equipment does cause 
harmful interference to radio or television 
reception, which can be determined by turning 
the equipment off and on, the user is 
encouraged to try to correct the interference by 
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the 
equipment and receiver.
- Connect the equipment into an outlet on a 
circuit different from that to which the receiver 
is connected.
- Consult the dealer or an experienced 
radio/TV technician for help.
RF Notice
Any changes or modifications to Symbol 
Technologies equipment not expressly approved 
by Symbol Technologies could void the user's 
authority to operate the equipment.
70-XXXXX-01
Copyright © 1998 by Symbol Technologies, Inc. All 
Rights Reserved.Symbol and Spectrum24 are 
registered trademarks of Symbol Technologies, Inc.
Symbol Technologies, Inc.
One Symbol Plaza
Holtsville, NY 11742-1300
Antenna
Earpiece
3 Line
10 Character
LCD Display
Right/Down
Scroll Button
Charging 
Contacts
LED Indicator
Volume
(Alternate Scroll 
Buttons)
Select
(Alternate Send 
Button)
Left/Up
Scroll Button
Microphone