COOPER INDUSTRIES INC 2072 Manual De Usuario
Installation
©PAT Rev. F 03/26/03
190136_f
5
4 INSTALLATION
4.1 TRANSMITTER/SWITCH
Install the standoff to the boom head using a 5/16x3/4” HEX bolt. The hole pattern for the standoff is
the same as that of conventional PAT A2B switches. In most cases the standoff can be mounted in
the same location as the conventional switch.
the same as that of conventional PAT A2B switches. In most cases the standoff can be mounted in
the same location as the conventional switch.
If not replacing an existing switch, the proper location would be one that allows the switch to rotate
freely without being obstructed by any part of the boom head. It should be mounted close to the dead
end mounting gusset. The switch should normally be mounted on the cab side of the crane.
freely without being obstructed by any part of the boom head. It should be mounted close to the dead
end mounting gusset. The switch should normally be mounted on the cab side of the crane.
For jib installations, locate the switch close to the jib head.
Remove the lynch pin from the standoff. Slide the A2B switch onto the standoff. Replace the lynch pin
into the standoff.
Install the weight and chain onto the A2B switch.