COOPER INDUSTRIES INC FH1847N Manual De Usuario
T245 Control System Manual
13
6.2. No-Link Data Mode
The third bank of switches (“MODE” 1 through 8) on the DEX-900 and REX-900
is used to select various features on the radio receiver. For the Versalift
Receiver/Controller, only position 5 should be ON. This sets the DEX-900 or
REX-900 to clear all its output data whenever there is no link or signal from the Radio
Transmitter of the right ID.
Receiver/Controller, only position 5 should be ON. This sets the DEX-900 or
REX-900 to clear all its output data whenever there is no link or signal from the Radio
Transmitter of the right ID.
6.3. Checksum Mode
The DEX-900 has a fourth bank of switches (“MODE” 9 through 16) for selecting
additional features. For the Versalift Receiver/Controller, only position 5 should be
ON. This sets the DEX-900 to use checksums when transferring data to and from the
R1300+ board.
ON. This sets the DEX-900 to use checksums when transferring data to and from the
R1300+ board.
6.4. Changing Switch Settings
To change the switch settings, use a ballpoint pen or small screwdriver to move
the switch levers. When you have set the levers to the right positions, turn the system
power off (usually by shutting off the vehicle’s PTO switch) and back on again. The
DEX-900 or REX-900 will take about 5 seconds to process your changes and then turn on
its red ON lamp. You must switch the power off and on whenever you change the
DEX-900/REX-900 switches, for the changes to take effect.
power off (usually by shutting off the vehicle’s PTO switch) and back on again. The
DEX-900 or REX-900 will take about 5 seconds to process your changes and then turn on
its red ON lamp. You must switch the power off and on whenever you change the
DEX-900/REX-900 switches, for the changes to take effect.