Garmin International Inc 0037600 Manual De Usuario

GTX 327 Installation Manual

Page 6

190-00187-02

Rev 1

When routing antenna cables, observe the following precautions:

•

All cable routing should be kept as short as possible and as direct as possible.

•

Avoid sharp bends.

•

Avoid routing cables near power sources (e.g., 400 Hz generators, trim motors, etc.) or near power
for fluorescent lighting.

•

Avoid routing cable near ADF antenna cable (allow at least a 12-inch separation).

The table below lists examples of the recommended antenna cable vendors and the type of cable to be used
for specific lengths of cable.  Any cable meeting specifications is acceptable for the installation.

5.5 to 10

M17/111-RG303

10 to 17.5

SF-304 or M17/127

17.5 to 27

SF-5394 or M17/79

Times Microwave Systems,

P.O. Box 5039

Wallington, CT 06492-5039

Tel: 203-949-8400

Fax: 203-949-8423

5.5 to 10

ECS 3C142B

10 to 17.5

ECS 311601

17.5 to 27

ECS 311201

27 to 41

ECS 310801

Electronic Cable Specialists,

5300 W. Franklin Drive

Franklin, WI 53132

Tel: 800-327-9473

414-421-5300

Fax: 414-421-5301

The antenna cable requires a BNC connector at the antenna and a male BNC “Blindmate” connector
(P/N 330-00198-00, supplied with GTX 327 installation kit 010-10216-00) at the transponder.  Instructions
for installing the Blindmate BNC are shown in steps A-G.  Follow BNC connector manufacturer instructions
for assembly of the BNC connector.