Garmin AT Inc. AT7000 Manual De Usuario
Installation
Installation Manual
Page 12
560-0405-00 Rev –
December 14, 2001
© 2001 by UPS Aviation Technologies Inc.
3.3.2.1 Mounting Tray
Figure 4 - ARINC 600 4 MCU Mounting Tray
3.3.3
Antenna Provisions
Install antenna in accordance with manufacturer specifications.
Sealant should be applied as required to the antenna base to prevent leakage of water and
condensation while also preventing corrosion. Any sealant or aerodynamic smoother used
around the edge of the antenna base must be applied only after the antenna has been
bolted and secured to the aircraft. Each antenna should have a maximum of 2.5 milli-ohm
ground bond resistance.
condensation while also preventing corrosion. Any sealant or aerodynamic smoother used
around the edge of the antenna base must be applied only after the antenna has been
bolted and secured to the aircraft. Each antenna should have a maximum of 2.5 milli-ohm
ground bond resistance.
Table 2 - Antenna Minimum Spacing
Antenna
Minimum Spacing
DM-N150-2 (Dorne-Margolin P/N)
S65-5366-7L (Sensor Systems P/N)
Or equivalent L-Band Antenna
20” from other L-band antennas in same
range.
range.