GatesAir Inc. CZF Manual De Usuario
APEX
™
Exciter Incorporating FLO
™
Technology
Navigating the LCD Display Screens
Details of the System Setup Screens
Page: 3-46
888-2604-001
03/08/07
WARNING: Disconnect primary power prior to servicing.
3.6.6.2
Serial Setup Screen 2 of 3, Ethernet
SerialSetup2.bmp
Figure 3-38 Serial Setup Screen 2 of 3, Ethernet
This screen is for programming the LAN 10 Base-T Ethernet port on the rear panel of the
exciter.
exciter.
At the present time the ethernet port is set to talk to the eCDi™, which is a transmitter
network interface unit. The APEX exciter software must be version 4.0 or later to activate
the ethernet port for use with eCDi. See the APEX Exciter Setup and the Setting APEX IP
Address sections of the eCDi technical manual (part number 888-2517-001) for detailed
instructions.
network interface unit. The APEX exciter software must be version 4.0 or later to activate
the ethernet port for use with eCDi. See the APEX Exciter Setup and the Setting APEX IP
Address sections of the eCDi technical manual (part number 888-2517-001) for detailed
instructions.
The IP address must be correct for the exciter to communicate with the eCDi.
The IP addresses for eCDi units with software revisions of 2.6 or later are as follows.
The IP addresses for eCDi units with software revisions of 2.6 or later are as follows.
• For exciter A the IP address is 192.168.217.200
• For exciter B the IP address is 192.168.217.201
The IP addresses for eCDi units with software revisions earlier than 2.6 are as follows.
• For exciter A the IP address is 192.168.0.200
• For exciter B the IP address is 192.168.0.201
The gateway address is unimportant when exciter is used with the PowerCD transmitter.
The Subnet Mask can remain at 255.255.255.0.
The MAC address is unique for each exciter and has been assigned to it during final test.
This number will stay with the exciter during software changes. The MAC address, along
with all user setups are stored in the controller board. If the controller board is changed in
the field, the user setups and the MAC address must be reentered. If lost, the MAC address
may be obtained from Harris, provided the exciter serial number is known.
This number will stay with the exciter during software changes. The MAC address, along
with all user setups are stored in the controller board. If the controller board is changed in
the field, the user setups and the MAC address must be reentered. If lost, the MAC address
may be obtained from Harris, provided the exciter serial number is known.
The MAC address is greyed out (locked) because the Setup Screen > Factory Setup window
is locked.
is locked.
To obtain the MAC address for a given exciter or to reenter the MAC address into an
exciter, contact Harris technical support. The serial number of the exciter must be
known in order to obtain the MAC address from Harris.
exciter, contact Harris technical support. The serial number of the exciter must be
known in order to obtain the MAC address from Harris.