Echostar Technologies LLC MC13213 Manual De Usuario

DISH Network Corporation, 9601 S. Meridian Blvd, Englewood, CO., (303) 723-1000, declares 

that: This device complies with Part 15 of the FCC Rules. Operation is subject to the following 

two conditions: (1) this device may not cause harmful interference, and (2) this device must 

accept any interference received, including interference that may cause undesired 

operation.This equipment has been tested and found to comply with the limits for a Class B 

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Do not make changes or modifications to this equipment. This could void the user’s authority to 

operate the equipment.
There are many devices that allow you to connect your antenna to your in-home distribution 

system such as splitters, and amplifiers. The FCC requires that the isolation between the 

antenna port and the network port of your system meet the following:

• 80dB from 54 MHz to 216 MHz, at least
• 60dB from 216 MHz to 550 MHz and at least
• 55dB from 550 MHz to 806 MHz

Measuring the isolation of a device requires specialized equipment. In most cases, it is easier to 
purchase a splitter or amplifier with the correctly specified isolation from your local television 
retailer. The above requirements are extracted from 47CFR15.115. For the complete text please 
visit WWW.FCC.GOV.

The software-based attenuator within the satellite receiver will limit the signal present at your 

television set to below the FCC signal strength limit of 75.6dBuV. If you choose not to enable the 

attenuator, you must ensure that the signal strength present at the TV set does not exceed 

75.6dBuV. 

In order to receive local broadcast channels, you may wish to install an over-the-air antenna into 

your over-the-air tuner module or TV distribution equipment. There are many devices that allow 

you to connect your antenna to your in-home distribution system such as splitters and amplifiers. 

You must be careful to meet certain FCC regulations with respect to the isolation between the 

antenna port and the network port of your system. It is recommended that you purchase a 

splitter or amplifier with the correctly specified isolation from your local satellite television retailer.